|
Don't bother with PSI
I built this one after realizing using the PSI would be a big PITA, which takes templates less than 1/4" thick and can't hold a plug to duplicate it. It is really intended for pen turning I think.
Total cost was about $100.
Materials- 2'x4' of 3/4" melamine coated shelf board
2'X4' of 3/4" birch plywood
1/4" birch plywood for templates
Epoxy
Various screws, nuts, bolts, washers
Cutter holder and carbide cutter (most expensive parts)
Spray adhesive to mount photo of plug to make template
Tools- Band/jig Saw
Table Saw
Drill press
Belt sander
Miter saw
Easily an afternoon project for you handy guys, but I took a bit longer due to inexperience.
|